|Shipping time||1 - 3 Tage**|
also called a hen house flap gate or electronic door opener / closer ( Automatic Hen House Door Opener / Closer ) automatically opens and closes flap gates or other optionally available vertical sliding gates using a cable pull on the poultry or hen house, aviary, or small animal enclosure via a dimmer switch. The sensitivity of the integrated dimmer switch can be set separately for light and darkness. If there is an animal under the flap the closing process, the motor of the automatic chicken flap HK2 is automatically stopped when it is put on. The emergency stop closing procedure is repeated 2 times automatically. The emergency stop function is deactivated on the fourth closing attempt.
The HK2 has a load-limiting device which performs shutdown in the event of the sliding gate being block or being subject to a level of weight that is too high. The HK2 is suitable for assembly indoors or outdoors and does not open in the event of a storm (lightening).
The two-sided mounted motor shaft and motor mounting bracket of the HK2 are made of solid stainless steel and therefore no maintenance is required.
The gate control unit functions without a mechanical limit switch and is therefore less susceptible to malfunctions.
- Connection for external push-buttons available
- Connection for external remote indication available
- Connection for external light control available
If you assembly the HK2 indoors, your require an outdoor SFH light sensor.
With our optionally available menu-driven electronic clock timer, the following functions can be set.
- HK2 opens or closes only with the clock timer, the light sensor is idle
- HK2 opens or closes only via light sensor , clock timer is idle
- HK2 opens or closes with the clock timer and light sensor
- HK2 opens or closes with the clock timer or light sensor
With the optionally available FB radio remote control, you can manually control the HK2.
The KS-SFH should be fastened in such a way that the internal cord is pulled straight out of the HK2 Electronic Gate Control Unit. Avoid pulling it out at an angle!
The sliding gate or the flap gate must fastened in the state of being open using the cord (cable pull) at the fastening point (adjusting ring), which is located at the bottom side of the housing (see assembly).
The cord (cable pull) of the sliding gate or the flap gate can be guided using the deflection rollers or the guide pulleys; therefore, attachment of the HK2 is variable (see assembly examples).
Scope of delivery:
- HK2 (Gate Control Unit) with integrated light sensor
- wall plug Transformer 230 V / 12 V DC (Approved for indoor use!)
- menu-guided timer switch (ZSU)
- flap 340x550mm
Due to the manufacturing process, there may be slight scratches on the aluminium parts of the flaps, which do not impair the functionality and therefore do not represent a defect!
The connecting cable between the flap actuator and the flap is not included in the scope of delivery
Not an assembly kit, no handicraft work, but a unit that is immediately ready for use!
3rd generation of self-sufficient automatic flap regulators - even better, more functions and safety features! There is no comparable device!